DO NOT SCRAP IT! MODERATED NATIONAL EXCHANGE NEWSGROUP FOR SALVAGERS > New Hampshire
> Construction
> Heat sealer teflon cover 18YD roll 5 mil 1.125" wide
Heat sealer teflon cover 18YD roll 5 mil 1.125" wide
Heat sealer teflon cover 18YD roll 5 mil 1.125" wide
Heat Sealer TEFLON COVER 18yd roll 5 mil 1.125" wide
TEFLON FABRIC COVER 18yd roll 5 mil 1.125" wide
This is the tape (non-adhesive) to use to cover the heating element on Impulse Sealers.
This Fibreglass reinforced Teflon fabric tape prevents your Poly bag or Shrink film from sticking to the heating element.
The roll is 18 yards x 5 mil x 1.125 wide.
These will fit most hand sealers such as TEW-200, TISH-200 FS-200
WHEN LOOKING AT OTHER KITS MAKE SURE YOU ARE GETTING THE PROPER PARTS NECESSARY FOR A PROPER JOB, YOU SHOULD HAVE THE FOLLOWING
* 1 REPLACEMENT Element (wire)
* 1 Teflon Fabric 5 mil cover that goes over the element 1.125" wide
* 1 Piece of 1/2 inch teflon tape(adhesive) 10 mil that goes under the element.
Failure to replace the teflon tape that insulates the element from the body of the sealer will cause premature failure of the element and may cause failure of the timing circuit or transformer.
Temporary Email: lreilly@dontscrapit.com (Lucile Reilly)
