DO NOT SCRAP IT! MODERATED NATIONAL EXCHANGE NEWSGROUP FOR SALVAGERS   >   Pennsylvania   >   Bar of 0-1 tool steel 7/16" x 2 1/8"

Bar of 0-1 tool steel 7/16" x 2 1/8"


Bar of 0-1 tool steel 7/16" x 2 1/8"

This is a bar of 0-1 tool steel that measures .437" x 2.125" x 4" . I have quite a few small pieces of this material , so if you need a small piece ask and i will see what i have . Most of the pieces are Stentor , Starrett or Brown & Sharpe . Almost all of it like this piece do have some surface rust on them .
* CHARACTERISTICS - O1 is an oil-hardening, non-deforming tool steel which can be hardened at relatively low temperatures. Tools and dies made from O-1 will have good wearing qualities since the tungsten and higher chromium content gives improved wear resistance over the straight manganese grades.
* WORKABILITY - - Machinability is high. Grindability is high.
* APPLICATIONS - Blanking Dies, Bushings, Forming Dies, Master Tools, Forming Rolls, Guages, Trim Dies
Temporary Email: D.Freeman@dontscrapit.com (Dale Freeman)




Bar of 0-1 tool steel 7/16