DO NOT SCRAP IT! MODERATED NATIONAL EXCHANGE NEWSGROUP FOR SALVAGERS > New Hampshire
> Commercial
> Miller 8VS wire feeder
Miller 8VS wire feeder
Miller 8VS wire feeder
ALL ARE CHECKED OVER BY CERTIFIED WELDERS!
Totally enclosed, impact-resistant, flame-retardant case provides strength and durability, and protects components and welding wire from moisture, dust and other contaminants.
Ergonomically sound, lightweight, modular design is well balanced, and allows improved mobility and ease of carrying to remote welding sites and for serviceability.
Standard contactor and gas solenoid prevent wire from becoming electrically hot.
Operates on open-circuit arc voltage eliminating need for power supply cord to power source.
Universal feeder operates with most Miller and competitive CV/CC DC-type power sources.
Flexibility to run a variety of wires up to 1/16 inch diameter.
Quick-change drive rolls are easy to change - no tools required.
Drive roll accessibility makes it easy to install wire, adjust tension and change drive rolls.
Carrying handle folds up out of operators way, yet large enough for a gloved hand to carry.
Gas purge purges gas line without feeding wire, or energizing weld wire with OVC.
Internal components are protected from damage by thermal overload protection which automatically shuts down the unit if duty cycle is exceeded or air flow and cooling are restricted.
* Flux Cored (FCAW) (gas and self-shielded)
* Operates on open-circuit voltage and arc voltage 15-100 VDC
* Solid Wire: .023-1/16 in (0.6-1.6 mm)
* Flux Cored: .030-1/16 in (0.8-1.6 mm)
* 50 - 700 IPM (1.3 - 17.8 m/min) depending on arc voltage
* 8 in (203 mm), 14 lb (6.4 kg)
Temporary Email: ijefferson@dontscrapit.com (Ila Jefferson)
