DO NOT SCRAP IT! MODERATED NATIONAL EXCHANGE NEWSGROUP FOR SALVAGERS > North Dakota
> Industrial
> 2X3 urethane lower english wheel 1/2" bearings
2X3 urethane lower english wheel 1/2" bearings
2X3 urethane lower english wheel 1/2" bearings
Exclusively Sold by Hoosier Pattern Inc
This Means that if the Item is; Delayed, Lost, Damaged or Whatever We Are Not Responsible.
Who are We? Can you Trust Our Quality? Want Answers?
Go to which is the Worlds Largest Metal Shaping Community. This site is Full of Guys and Gals doing Everything you could imagine when it comes to Body Repair, Scratch Built Cars and Bikes, Airplane Repair, Artist, Fabricators, and Guys and Gals just tinkering around. Metal Meet has an International Meet once a Year in centrally located Oblong IL, and Many of it's Members host Smaller Regional Events to further Share the Metal Shaping knowledge. My user name on Metal Meet is Joe Andrews, the Company Hoosier Pattern either name can be searched on Metal Meets Site.
CNC Precision Machined Urethane Lower Anvil
Hardness is 75 on Durometer A Scale
This is the Highest Quality Urethane Wheel Made
If you’re going to do it, Do It Right!
The Wheel Shown is Green, This is the same color as All of Our Urethane Lower Anvils.
This Wheel is normally to Tip edges(Flanges) on your Panels. Tipping is done with a Thin Upper Wheel, Please Check Our Store for Tipping Wheels. Tipping is Extremely Fast and Accurate without Distorting your Panels Surrounding Area. Embossing is Awesome to see done, here is an example...Take a piece of Carboard cut to whatever Shapes you desire, Flames are used a Lot. Tape the Cut Out to the Underside Surface of Your Panel. Next using Your Standard Upper Wheel with a Urethane Lower Anvil Apply Enough Pressure to Your Machine to start the Embossing Process. In just a Few Passes you will start to see the Shape you cut Raising itself. If you want your embossing to Sink into the Panel put the Form on the Top of your Panel. This is an Easy Process to do, and if you want more or less Lift to your Embossing try thicker and Thinner Cut Outs. This Process can Also be done with a Urethane Upper Wheel and a Flat Steel Lower Anvil.
* This Anvil has 1/2" Bearings Installed
* Machined to 1.875 wide(we Include two Flat washers to get you to 2 Inch exactly).
* Washers are used because with Force the Sides of Urethane Bulges (Goes back to normal after about 5 Minutes)
* Machined Undersize to Keep from Binding Up in Your Yoke.
Our Bearings have the highest Load Rate offered!
© Copyright 1999 - 2008, All Rights Reserved
Hoosier Pattern, Inc. Abby_Mcfadden@dontscrapit.com
If you want to speak with me direct call me toll free at 1-(***)-480-4870 between 7:00 a.m. till 4:30 p.m. Central Monday thru Thursday and noon on Friday and ask for Joe Andrews
Temporary Email: Abby_Mcfadden@dontscrapit.com (Abby Mcfadden)
