DO NOT SCRAP IT! MODERATED NATIONAL EXCHANGE NEWSGROUP FOR SALVAGERS > Wisconsin
> Industrial
> Lapping machine model #24 by lapmaster w/ accesories
Lapping machine model #24 by lapmaster w/ accesories
Lapping machine model #24 by lapmaster w/ accesories
You are viewing a USED Lapping Machine, Manufactured in the U.S.A. by a Member of the
National Machine Tool Builders Association (NMBA)
LAPMASTER (Crane Packing Company)
Volts 220 * Cycle 60 * Phase 1
Pads, Discs and Weights are 9-3/4" in diameter
Discs pictured on top of the lapping table are 11-1/4" diameter
Approximate Dimensions: 54" Tall, 48" Wide, 56" Long
Included are various size pump barrels for piston lapping, wrench, light and lenz also included.
This Machine is Fully Opperable And In Good Working Condition, but is currently disconnected and ready to be transported. To the Best of my knowledge a new motor was installed approximately ten years ago. Please check pictures closely as the light tower has a cracked base and the gauge lenz is cracked, both minor problems, also two of the copper liquid feed tubes are missing and would need to be replaced.
Call Mike at (***)-430-4000 Ext. 259 to Arrange Appointment.
Temporary Email: A_Hale@dontscrapit.com (Allison Hale)
