DO NOT SCRAP IT! MODERATED NATIONAL EXCHANGE NEWSGROUP FOR SALVAGERS > Wisconsin
> Industrial
> Shaft sleeves machined for emergency repair, exc. cond
Shaft sleeves machined for emergency repair, exc. cond
Shaft sleeves machined for emergency repair, exc. cond
Two steel sleeves made in a machine shop to close tolerances - sized for standard larger HVAC blower shaft and bearing sizes. Perfect for use when Pillow Block or Flange Bearings have failed and scored the shaft. Many times replacing the fan shaft proves impractical, a major problem.
No need to remove the shaft from the fan cage housing. Remove the bad bearing, clean and dress the existing shaft at the worn surface.
Increase the new bearing size, slide the sleeve over the scored shaft , drill and tap the sleeve for locking set screws, complete and place fan back into service.
(1) 1-3/16" ID x 1-7/16" OD x 5" Long
(1) 1-7/16" ID x 1-15/16" OD x 6" Long
New, never used, carried in service vehicle for long time, oil dried off.
All surfaces are in excellent condition, slight oxidization is cleaned off.
Temporary Email: R_cline@dontscrapit.com (Ramona Cline)
