DO NOT SCRAP IT! MODERATED NATIONAL EXCHANGE NEWSGROUP FOR SALVAGERS > Idaho
> Industrial
> Repair kit: for 16" impulse sealer (flat wire)$1.50 s&h
Repair kit: for 16" impulse sealer (flat wire)$1.50 s&h
Repair kit: for 16" impulse sealer (flat wire)$1.50 s&h
Repair Kit: for 16" Impulse Sealer (Flat Wire)$1.50 S&H
Repair Kit: Teflon Cover & (FLat Wire)Element for 16" Impulse Sealer
WHEN LOOKING AT OTHER KITS MAKE SURE YOU ARE GETTING ALL THE PARTS NECESSARY FOR A PROPER JOB, YOU SHOULD HAVE THE FOLLOWING
* 1 REPLACEMENT Element (wire)
* 1 Teflon Fabric 5 mil cover that goes over the element 1.125" wide
* 1 Piece of 1/2 inch teflon tape(adhesive) 10 mil that goes under the element.
Failure to replace the teflon tape that insulates the element from the body of the sealer will cause premature failure of the element and may cause failure of the timing circuit or transformer.
Included are Detailed instructions on installing new elements and teflon covers.
Also tips on how to prevent elements from burning out.
Temporary Email: billybanks@dontscrapit.com (Billy Banks)
